Ytterligare specifikationer, utrustning och information:
Tillverkare: Aragosa Yachts, Toronto, Canada
Designer: Ted Brewer
Registrerad i: Storbritannien
Köl: full köl
LÖA Längd över allt: 60 fot 5 tum
Bredd: 16 fot 7 tum
Min. djupgång: 6 fot 0 tum
Max. djupgång: 6 fot 0 tum
Ballast: 21000 pund
torrvikt: 60225 pund
Total effekt: 135 HP
Propeller: 3-bladig propeller
Motorstyrka: 135 HP
Färskvattentankar: 5 Aluminium (375)
Bränsletankar: 5 Aluminium (300)
Antal singelbäddar: 3
Antal dubbelsängar: 2
Antal hytter: 3
Antal toaletter: 2
Antal badrum: 2
Full forward is the extra large bathroom with two sinks and vanities. This cabin was originally two small crew cabins and the bulkhead has been moved backwards to provide a vast sail/fender locker adjoining the chain locker. Moving aft, a good size double cabin lies to port with shower/hip bath and a single cabin is found to starboard. All cabins are fitted with hanging lockers, drawers and book shelves.
The saloon is expansive, taking full advantage of Mora's 16'7" beam. To port, a dining table accommodates up to eight with further seating to starboard. The saloon also provides two excellent full length pilot berths. Stowage is found beneath all seating and berths. Further stowage can be accessed below the cabin sole with additional lined areas and drawers The cabinetry throughout is in teak and cherry.
Moving aft, the galley is to port, leading to a double stateroom with adjoining en-suite head and shower. To starboard, adjacent to the companionway, the navigation station houses instrumentation, the AC and DC electrical panels, and a full size chart table. Further aft lies the dedicated workroom, from which the (standing height) engine room is accessed.
The galley has good countertop and cupboard space throughout. Equipment includes: double stainless steel sink and mixer tap; Force 10 three burner gas stove and oven; top loading 70 litre and two 40 litre 12 volt fridge/freezers all fitted with smart speed controllers; microwave oven. A highly efficient and quiet SPECTRA Catalina 300 watermaker gives 47 litres per hour while running on just 15 amps at 12 volts DC.
There are two showers on board, both with self-contained sumps (automatic pump). Hot and cold pressurised water.
Two LAVAC heads. Both have electric pumps with manual pumps plumbed in-line for backup.
Batteries and Electrics
The yacht's AC system accommodates 110v and 220v. AC can be provided either from shore power or the PROSINE 4500 WATT inverter. The yacht's DC system is 12VDC with a large house bank of six 8D Gel Cell batteries totalling 1200 amps. There is a separate start battery. DC charging is from five solar panels totalling 600 watts. There are also twin large-frame alternators on the engine for rapid charging under power. There is a 20 amp AC charger. Wiring is all tinned.
There are two heavy duty RULE automatic electric bilge pumps, together with manual high volume pumps. and a non automatic electric pump.
Electronics & Navigation
- RAYMARINE autopilot (linear drive)
- ICOM ICM402S VHF radio
- ICOM IC718 HF radio
- RAYMARINE 2 kw radome
- RAYMARINE C80 chartplotter
- RAYMARINE fixed GPS
- GARMIN h/h GPS
- MATSUTEC AIS transponder
- VESPER MARINE AIS Display
Mast & Rigging
Masthead ketch rig. Both masts are keel stepped and were un-stepped in 2008 to facilitate rig inspection and the installation of HARKEN track. The mast wedges were replaced with SPARTITE - a one-piece custom mast chock that seals the cavity between the mast and the partners. The slab reefed main and mizzen both run on Harken batt cars. This system was adopted to replace the original mast furling. As well as allowing a more efficient sail shape, the sails can now be reefed much faster and on any point of sail directly from the cockpit. The ketch rig, as well as splitting the sailpower into easy to handle loads, also gives greater options to balance the yacht over a sloop rig, keeping the helm light.
NITRONIC rod rigging. (ND tested 2009)
NAVTEC hydraulic backstay tensioner.
NAVTEC hydraulic boom vang.
Mast mounted spinnaker pole on track.
Running rigging is spectra/dacron, with a full complement of spare lines on board.
- 2 x LEWMAR #65 self tailing winches
- 6 x LEWMAR #46 self tailing winches
- 2 x LEWMAR #40 self tailing winches
8 x deck cleats
LEWMAR headsail sheet track and cars
dual line reefing controls led back to cockpit
- FLEMING windvane (not fitted)
- Dorade vents with s/s grabs
- Deck mounted dinghy chocks
- Stainless steel guardrail c/w gates both sides
- Stainless bimini frame for solar panels
- Swim ladder
- Transom steps
- Mainsail (slab reefed, traditional battens)
- Mizzen (slab reefed, traditional battens)
- Genoa (on PROFURL furler)
- Staysail (on PROFURL furler)
- Storm sails
- Spinnaker (in sock)
Both furling headsails are well used. Main and mizzen good condition.
- GME MT403 EPIRB
- GME MT410G EPIRB
- AVON life raft (out of service)
- Life sling
- Fire blanket+fire extinguishers (automatic in engine room)
- WHALE manual bilge pump
- Gas detector
- MAXWELL VWC 3500 windlass c/w remote (controlled either from bow or cockpit)
- MANSON 'Supreme' 125 lb anchor
- FORTRESS FX85 47 lb
- 2 x 200' 3/8 G40 high test chain
- Anchor rode
Covers & Awnings
SUNBRELLA sprayhood and bimini. There are also SUNBRELLA windscoops for the hatches and PVC awnings for the deck.
Dinghy & Outboards
3m NAIAD RIB. This has a double skinned aluminium hull and pontoons consist of outer and inner tubes making them replaceable (due now). This dinghy was modified by the manufacturer to be certified for use as a life raft. The TOHATSU 9.8hp two stroke engine is reliable and lightweight, and powerful enough to plane whilst carrying two.
The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.
*This price is based on today's currency conversion rate.