Ytterligare specifikationer, utrustning och information:
LÖA Längd över allt: 36 fot 5 tum
Bredd: 12 fot 6 tum
LWL: 31 fot 2 tum
torrvikt: 12789 pund
Engine Option 1: 1x
Färskvattentankar: (81 Gallon)
Bränsletankar: (19 Gallon)
Antal toaletter: 1
The layout of the 362/363 has two or three cabins, one head and shower, a spacious saloon and galley and separate chain locker forward.
The interior is a varnished cherry finish. All bulkheads are bonded and glassed to the hull, giving superb strength and rigidity. The cabin sole is of durable, low maintenance teak and holly composite floor panels.
Seat covers are off-white breathable upholstery and the berth mattresses are covered in washable fabric.
Styling, comfort and durability were priorities.
Non-skid finish on companionway steps.
The yacht's electrical system is full 12V with the capability of being plugged into shore power.
AC breaker panel for hot water heater, outlets and battery charger.
Two heavy-duty gel-cell** house batteries, with master switches.
16-switch 12v electrical panel that includes a volt and ammeter for monitoring the house batteries.
Copper grounding strap from shroud to keel.
Stereo radio/cassette/CD player, two below deck speakers and two cockpit speakers.
Multi-channel VHF radio with LCD display and 25 watt maximum power output.
Sailing instruments include depth sounder, speed and distance log.
Windspeed and wind direction indicator.*
Navigation lights, steaming light, masthead light, deck light and compass light.
Interior lighting is provided by overhead halogen spotlights, fluorescent strip lights and reading lights.
Each stateroom is served with a variable speed fan. Two fans are fitted in the saloon.
12V outlet at chart table.
Shore power system has a direct wired 50’/15M power cord.
Each cabin as well as the galley has a shore power plug outlet.
The water heater has a 110V/220V heating element.
20 amp battery charger.
The spacious galley allows ample workspace for two people. All counter tops are a combination Formica/Antium. There is a deep double sink of stainless steel with mixer faucet for hot and cold water.
A 10gal/38L garbage bin is included.
A two-burner stainless steel stove with oven has an LPG shut-off solenoid. The stove is fully gimbaled and has pot clamps and heat guard.
Behind the galley along the port side are separate lockers for cutlery, crockery and all cooking utensils. Above these lockers is a shelf with fiddles.
12volt refrigeration system with single plate, spillover system serving a foam insulated icebox.
The refrigerator boxes can be pumped out by a 12V pump.
Yanmar 3GM-30 27HP naturally aspirated diesel engine.
Manual engine shut-off.
Push button engine start, in lieu of key.
Reinforced cutlass bearing.
Racor 500FG water separator fuel filter.
One isolated gel-cell** engine battery.
90 amp alternator with three step regulator and isolation diode.**
Three blade propeller on stainless steel shaft.
Engine instruments include gauges for RPM, fuel, ammeter, oil pressure, engine hour counter and water temperature. A sound alarm is provided to indicate high freshwater temperature and low oil pressure.
Single lever engine controls mounted on the pedestal.
Fuel capacity is 21gal/80L in single tank, located aft amidships. The tank has an emergency fuel shut-off, inspection hole and drain plug.
Stainless steel destroyer wheel coupled in a cast aluminum quadrant via chain and cables.
The hull is hand laid-up GRP construction using multi-layers of glass roving and polyester resin. The hull carries a comprehensive limited warranty against osmosis blistering.
The interior of the hull has an Integral Grid Unit (IGU) giving longitudinal and latitudinal support to the hull and keel.
Keel ballast is iron.
Deck and hull are finished in white gel-coat, with the trademark Moorings striping and graphics.
The deck has a molded-in non-skid diamond pattern, providing excellent traction even in the most severe conditions.
The hull-to-deck joint is chemically bonded with an elastomer sealant and further secured with an anodized aluminum caprail, and attached every 6"/7.6cm.
Stainless steel keel bolt washers.
Deck storage includes one large cockpit locker and one transom locker, all self-draining.
The fully sealed LPG locker meets ABYC and CE standards and is capable of holding two 10Lb / 4.5Kg gas cylinders.
The rigid swim ladder can be folded on the swim platform.
A deck shower neatly concealed in its own compartment, on the transom.
The helmseat is removable to allow easy access to the swim platform.
The cockpit has a large table with an integral icebox, grab handle, drink holders, light and instrument pod.
The binnacle compass is uniquely positioned for excellent viewing.
There are grab rails along both port and starboard sides of the coachroof and companionway.
Protection bar is fitted around forward hatch.
Mast & Rigging
Anodized aluminum, deck-stepped mast with double swept back spreaders. Four mast sheaves of aluminum. All mast wiring is run through a mast conduit. Cleats and rope clutches are added to the mast.
Cast aluminum mast collar has support for six foot blocks for halyards, reef lines outhaul and mainsheet.
Mast exits are fitted for topping lift and pole lift.
The boom is equipped with two reefing lines and reefing hooks, the outhaul is led back to the cockpit.
Rope boom vang equipped with jam cleat and quick release shackle.
Windex wind indicator on mast head.
ProFurl roller furling Genoa system.
Discontinuous stainless steel 1 x 19 wire standing rigging. Cap shrouds and forward lowers are anchored to the IGU by stainless steel tie-rods. Double backstays allow free access to the swim platform.
All shrouds have swaged-on stainless steel end fittings and stemballs. Lower ends are fixed to custom deck plates with chromed bronze double screw turnbuckles.
Two Lewmar 30 CST two speed winches serve all lines and halyards led aft from the mast.
Genoa sheet winches are Lewmar 44 CST two speed.
Two winch handles with plastic handle holders.
Eight racked rope clutches.
Two genoa T-tracks are mounted on the side deck.
Two genoa cars and spring loaded car stops on each genoa track.
Mainsheet track with four part traveler control lines run through rope clutches.
Vertical electric windlass with chain gypsy and rode drum and hand-held remote control operating up/down switch.
Three cast aluminum mooring cleats with fair-leads are mounted on port and starboard sides of the deck for dock lines (total 6).
Stainless steel double rail pulpit and pushpit. The pushpit incorporates a flagpole holder, horseshoe ring, outboard bracket and removable upper life line to allow access to the swim platform.
Stainless steel tapered stanchions with double stainless steel wire life lines and gates port and starboard.
Stainless steel stemhead fitting with single roller.
Two Size 30 Lewmar hatches serve the saloon and forward cabin.
One Size 20 Lewmar hatch serves the aft cabin.**
Two Size 20 Lewmar hatches serve the aft cabins.*
Seven Lewmar opening port lights.
All overhead hatches have roller blinds.
Two lockable teak companionway hatch boards with vent.
Bimini with stainless steel frame.
Hanging cockpit light.
Aluminum cap covering emergency tiller attachment.
Sails & Running Rigging
Semi-full battened Mainsail of 300sqft/30sqM, furling genoa 370sqft/37sqM built to Moorings specifications.
Asymmetrical Spinnaker. *
Spare 3/8"/10mm genoa halyard.
The genoa sheets are pre-stretched Dacron 1/2"/12mm diameter line, 3/8"/10mm main halyard, 3/8"/10mm genoa halyard, 5/16"/8mm outhaul, 2 x 5/16"/8mm reef lines, 7/16"/11mm mainsheet and 5/16"/8mm roller furling line are all of pre-stretched Dacron.
Moorings SailMate self-stacking mainsail handling system with lazy jacks and integral sail cover.